Shop

AirRx Airwire Receiver

$69.00

Airwire RX

Out of stock

Category:

Description

This is an Airwire compatible receiver. It can operate on all 16 radio channels. In addition to receiving the over-the-air DCC signal from the T5000 and passing it to the ‘D’ output on the receiver, it also features two servo outputs and two digital outputs. The servos can be configured in three ways- Live Steam, ESC, and Coupler modes. In the Live Steam mode, servo 0 follows the throttle output while servo 1 responds to the direction. In ESC mode, the servo 0 output is configured as a ‘center off’ output to drive electronic speed controllers. In coupler mode, the servos respond to a programmable function code. The digital outputs can be configured to be ‘low off’ or ‘low on’ and a function code can be assigned to each. All functions are programmable via CV writes, the following map shows all of the available parameters:

/*
 * Decode message packets here and do servos and config variables
 *
 *   CV 201 - Radio Channel 0-15
 *   CV 202 - DCC Address lo
 *   CV 203 - DCC Address hi
 *   CV 204 - Servo Mode 0=Steam, 1=couplers, 2=ESC
 *   CV 205 - Servo0 LowLimit Lo
 *   CV 206 - Servo0 LowLimit Hi
 *   CV 207 - Servo0 HighLimit Lo
 *   CV 208 - Servo0 HighLimit Hi
 *   CV 209 - Servo0 Reverse
 *   CV 210 - Servo1 LowLimit Lo
 *   CV 211 - Servo1 LowLimit Hi
 *   CV 212 - Servo1 HighLimit Lo
 *   CV 213 - Servo1 HighLimit Hi
 *   CV 214 - Servo1 Reverse
 *   CV 215 - Function Code for Coupler 0
 *   CV 216 - Function Code for Coupler 1
 *   CV 217 - Function Code for Output x
 *   CV 218 - Function Code for Output y
 *   CV 219 - On/Off Code for Output x
 *   CV 220 - On/Off Code for Output y
 *   CV 230 - Reset to factory defaults
 */